C W Burfle posted:How would one go about adding a bearing to a fiber brush plate? In particular, I am wonder about how to get the proper alignment.
1) Square up the plate on a drill press.
2) Drill out the bearing with an appropriate bit (in this case, a #12 bit, .1890 inch diameter).
3) Press bushing into place. Secure with ACC or epoxy glue.
4) Reassemble, lubricate and run!
In a pinch, one can simply drill out the bearing hole with a hand drill or Dremel, but precision is not guaranteed using this method. ;-D
Mitch