Skip to main content

Reply to "Greasing a 18009 Mohawk"

harmonyards posted:
Ponz posted:
harmonyards posted:

You can try what Rod said to do and see if you can squeeze grease from a small tube into the holes marked grease....I find that a lot of these Mohawks with their age, have the grease dried up in them. This makes it necessary to remove the worm gear cover and the worm shaft and clean out all that dried up gook for smooth performance......if you are uncomfortable doing that, then have it serviced by someone that can..........Pat  

Will that grease I mentioned be OK?

Ain’t gonna hurt it, that’s for sure...your only problem is getting it out of the can and into the tiny hole.....most of us keep a small tube of grease, or what’s called a pin grease gun handy for such jobs.....any grease is better than dried up rocks........Pat

Well, I found an applicator that worked.  She seems to be running a bit smoother, although it just might be my imagination.  I'll look again after some run time to see if she'll accept more grease.

Thank you

Ponz

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×