UP 4-6-6-4 2-tone grey challenger and CNJ 4-6-4T.
UP 4-6-6-4 imported by Tenshodo in 1999; decoder install (TCS 1517).
Made the 8-pin connector between the tender and engine plus 2 head lights and red marker lights for the tender.
Used an old PFM speaker.
Some foam along the top of the tender. The 8-pin connector protrudes out a rectangular hole under the deck plate.
4 of the wires connected to the back engine and motor.
The other 4 wires go to the boiler.
Soldered the wires on the 'other side' of the 8-pin connector.
Programming track.
New data loaded into the decoder and 'saved'.
Next: route all the boiler LED wires and connect them to the remaining 4 wires.
This engine has 2 motors so will have to 'diagnose' routing wires to it and still be able to remove the 'unit' from the boiler using another wire connector.
===============
CNJ 4-6-4T imported by PFM (United) in 1969.
Installed the 0402 LED's in this engine.
For such a small engine (being a 'tank' engine) it'll be lighted like a Christmas tree.
Besides headlight, 2 green marker lights, plus....
Head light and 2 red marker lights on the 'tank' and 2 LED's for the 'running board' ligthts'
