New delivery.
Micromark had some sales so I bought some 'needed' stuff.
Woodland light and hub set: just bought the 'controller' and will provide my own power and LED's (set comes with two of them) to check out setting up lighting for buildings, etc.
A small, accurate, digital scale.
Some 'plastic welder': will test this to see if same as MEK, acetone or lacquer thinner.
The thin tube has a 'touch N flow' applicator for applying thin glue, ie 'plastic welder'.
A very small miter box: A cutting saw is sold separately but I thought a razor saw would work but it's too wide so I'm just going to 'run' the razor saw through it to enlarge the slots.
Brass bar clamps. These things are, usually, very expensive but they had 2 for 10 bucks so I bought 4 more.
You get what you pay for:
I thought the new clamps were the same as my old ones.
They are shorter by an inch over my old bar clamps (right in picture). Also, not as heavy stock and just a dial type handle versus my old wing nut type on the old clamps.
Should be good enough, though, for securing some building sides during assembly.