Skip to main content

Reply to "Havent seen a Smoke Unit this Bad...."

@Junior posted:

Is there some trick to getting the resistors off the smoke unit board? I tried heating up the wire leads with my soldering iron (at what appears to be the soldering pad) but the leads aren't budging. Has anyone encountered this problem?

They use higher temperature solder on those.  I clean the solder joint throughly and then I turn up the soldering iron to 650F and put a spot of solder on the tip to conduct heat to the joint.  You can also cut the resistor free at the resistor body and clip some forceps on it to yank it out.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×