Skip to main content

Reply to "Heat Shrink Tubing"

RSJB18 posted:

Pencil type lighter. quick and easy as long as you are not too close to sensitive parts.

https://encrypted-tbn3.gstatic.com/shopping?q=tbn:ANd9GcQwJTS3NBQnnR7Hi5GZiqN_C5lNubRlkjETC0A50Zemz71wpWGXb48-Fvo52g1E5empiLoDW0T-&usqp=CAc

 

I use this same tool.  Just wave the flame on the tubing for a few seconds and done.  I used to use a soldering iron tip held close but when I visited TrainAmerica Studios I saw all of the techs there using regular Bic lighters on the heat shrink tubing when doing locomotive upgrades.  Hey, if it was good enough for Mike Reagan's shop then it was good enough for me and MUCH faster than the soldering iron method.

I've never set the tubing or wire insulation on fire with the lighter.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×