Dave,
Deleted all engines from remote, re-entered all and the old address came up again.
That's because deleting an engine doesn't change its internal DCS ID# (engine #).
Figured the TIU might have a memory for addresses so I did a factory reset of the TIU and repeated the above steps with the same result.
That's because resetting the TIU also doesn't change the DCS ID# of any engines.
think I will try this again using a short test track I have rather than do it on the layout
That will yield the exact same result. Instead of doing that again, follow Gregg's instructions above.
 | This and a whole lot more is all in “The DCS Companion 3rd Edition!" This book is available from many fine OGR advertisers and forum sponsors, or as an eBook or a printed book at OGR’s web store! |
