@GeoPeg posted:@gunrunnerjohn, any chance you would know a part number for the 24 pin headers? If I have to, I'll cut them off close to the plastic thingy, and desolder them one by one. Tedious, but doable as opposed to trying to reposition the existing headers - that's a non-starter for me!
George
PS looks like 2.5mm pin spacing
Actually, using a hot air tool, you could fairly easily reposition those headers. For removal/replacement, I cut something like that flush with the board on both sides, then remove the remaining stub and clear the holes. That's fairly tedious and if you're not careful, you can easily wreck the PCB. BTW, they're 2.54mm spacing, or 0.1". The 90 degree header stock is readily available, you just trim to size.
Truthfully, I'd probably put the effort into finding a similar motherboard and adapting it. I'm guessing the one that Bob pointed out may be a close to exact match. All the connector numbers are the same size and number of pins, not to mention being in the exact same positions.
Don't make this harder than it has to be.