Skip to main content

Reply to "How to get at the drive mechanism of a legacy circa 2000 EM-1"

Thank you John and Harmon

I just drilled out the U joint and tried a 2-M machine screw but found it just stripped.  I ordered a tap and hopefully can soon have it at least connected.

What I am curious about is the angle the motor is making with the shaft.  It looks to be way off.  So you all have thoughts on this?

It also looks as though I would have to remove the rear drive wheels to get to the screws holding the motor bracket from below.  Any comments or advise on this would be appreciated.

Attachments

Images (1)
  • EM-1_motor
Last edited by Robbin
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
×