Skip to main content

Reply to "How-To guide on making a “Pacific” series sleeping car (Finished?)"

@T.Albers posted:

The horizontal nameplate was made from a strip of styrene.  It was the very last detail I applied to the outside of the shell.  It’s mounted on top of of the fluted side like the Budd prototype.  As far as I could see Budd bolted these plates on the side of the car and they did not use groves on the back of the name plates.  

  Thank you for the feedback!  Here’s a close up view.

Thank you for the info!

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
×