Skip to main content

Reply to "How to replace the drive gear of an MTH tinplate locomotive?"

@GGG posted:

Yes, but looking at your picture you are correct AC was plugged into the wrong spot so possible several of the transistors and cap are shot.  If you wan to send to me I can look at it.  I may also have that specific top board in my parts.  G

I have a feeling it's the cap. I tested the 2sb772 transistor with my multimeter and was getting readings, so I assume that one's ok. I'm going to replace the cap, the KTA1266 transistor (which was the one that burned up), and the 5v voltage regulator since I still have a few left over.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×