As all my PS3 steamers eventually lose control or stop outright via DCS remote, ostensibly due to wireless drawbar pins coming just a tad loose at tender connection, I purchased the cover caps from MTH (part #FB0000028). I've been able to insert them successfully on a couple of steamers - but not on others. Is there a way the caps are supposed to be installed? I noted a white dot on the one end of the cap - I believe it is supposed to face down on the tender side. I am afraid to use too much force on these, or is a lot of force required sometimes? These drawbar pins coming loose at the tender plug is a real PITA IMO.
Original Post