Skip to main content

Reply to "I accidently hit the red button and now can't restore operation."

I've done this myself a time or two. Turning off power to everything (including the remote), then restarting it all fixed the problem. This should reset everything and you should be ready to run again. If you reset the TIU and Remote you could possibly have some setup work to do once you get going again.

A TIU can be powered one of two ways. 1. Powering the Aux port (recommended). 2. Powering Fixed Input 1. If using Fixed Input 1 and that breaker trips here you lose all DCS control over any tracks that remain powered. Reason for using the Aux port, if you have a short or derailment on any track and the breaker trips your TIU remains powered. Powering any of the other Inputs doesn't power the TIU.

If you powered Fixed Input 2 without powering the Aux port or Fixed 1 you will not get any DCS signal because the TIU is not powered, so you have basically a conventional track. 

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×