Skip to main content

Reply to "I cannot get my line master big boy programmed with my legacy 990 remote control"

Switch the engine to PROG, turn on track power to 18vac, enter the address you wish to use (XX), press set on the CAB2, the horn blows, turn off power, switch the engine to RUN, turn the power on again to 18 vac, press eng on the CAB2 and enter the XX number you used, press the ON button on the CAB2 (the lowest left button on the key pad). Operate the engine with the CAB2.

Is that what you did?

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×