Skip to main content

Reply to "Indianapolis O Scale and S Scale Midwest Show"

rrjjf posted:

The CLW H-10 frame must be assembled from steel side frames and various cross members.  Do you have the axle bearings and dummy spring hangers that fit this frame?  If not you might be better to find a complete kit on ebay.  They show up from time to time.  Finding "Section1" for this kit by itself may be difficult.

Joe

 

 

I have sections 3 & 4 and am missing the first two sections, so basically frame drivers, cylinders, side rods, motor etc.  I do keep an eye out on the bay for parts, but that is hit or miss you know.  I understand it is probably more likely that I would find a complete engine than just the drivetrain, but hey the fun is in the journey right?    If I understand correctly, the early version (Saginaw and maybe the early CLW) had cast bronze frames and the later ones were fabricated.  My tender is the later version with the brass sheet sides versus the early one with the cast tender.  Probably lots of ways to go.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×