Forum advice requested. I'm installing the shelving and I am pleased with it so far. I am using a carbide tipped power mitre saw that is making nice clean easy cuts. The lowest row and desired height took me a little time to do. Also, have my spacing blocks ready. I decided on 5 3/4 inches. I have some longer runs and had planned to use the connecting pins but haven't figure out how to open them up enough to slide or tap them onto the rails. I am pounding them with a center punch and its not working out. Maybe I wont need them but I am not the most talented or lucky when it comes to this type of stuff. I'd like to hear how others have set up their shelves before I am too far along and specifically:
Did you use these connecting pins, how did you get them open enough?
If you went to a corner, did you 45 degree mitre them or just keep them square?
