Skip to main content

Reply to "Interesting change in the PS32 Boards"

There was a large batch of 3/2 boards intended for G-gauge using the remotely mounted bridge rectifier.  They were modified to move the rectifier to the board for use in O gauge and Tinplate, however the rectifier on some boards was set too deep into the PCB so the heat sink has to modified to properly fit when mounted to a chassis. (No, I didn't do this, but I know who did).

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×