Like I said before I have a new regulator ordered, JGR, keeps saying about having the wiring correct, (he's right) so I went back (again) with the help of the wiring diagram, (thank you) and not knowing anything about electronics I can only tell you what I saw, the black wire or wires go to frame ground, the red goes to the on / off switch, the black and brown goes to the smoke unit, and the brown goes to a yellow wire nut which also contains two blue and one purple and white, one blue goes to a 3 prong plug on the mother board with the R4LC RCVR BRD attached to it, next to that plug is j4, grd /grd ser, the other blue goes to a 10 pin plug on the DCDS-J motor driver board with j4 next to it and the purple and white looks like it goes to the I.R. transmitter, this is the way the old regulator was wired, I did not change it, if you think this is correct I'll wire the second new regulator the same way.
|