Skip to main content

Reply to "K Line MDK-034 Streamlighting Board"

The LED strips I bought had a backing tape that I pealed off to reveal a contact glue surface. Just stick them to the inside roof of the car. If you want a little extra security, add a little hot melt dab across the tape after you have it stuck to the roof. BTW, measure and solder the leads to the tape first! It's easier that way... Speaking of solder, flux is your friend! I put a little on the pads of  the tape and then quickly melt a small blob of solder to the pad. Strip and tin the leads, add flux, and then hold the wire in place on the tape and touch the soldering iron to it. The solder quickly melts and makes the joint.

Chris

LVHR

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×