Good morning @DOUBLEDAZ
I understand that AutoCAD drawings do not convert 1to1 for these track layouts but I think that I can get just a bit more open space in my Layout if this drawings works. See the black circle in the inside corner of the "inset" of the table top. There is a 3/4" clearance between the edge of the Track and the edge of the table the way that I have the Tracks drawn. The "angle" of the inset is currently at 45 degrees, but I can change that to 60 degrees which would move the angle further away from the track and more toward the center of the table. This would allow the Bottom of the Outside Track (0-54) to be closer to in edge of the table ( 2-7/16" on the long run ) thus allowing a bit more Open Space. What do you think?