Skip to main content

Reply to "LCRU problems"

1) The antenna wire is just that -- an antenna -- and it shouldn't be connected to anything. Grounding it out will force the board into conventional mode, and I'm afraid to even know what connecting that output to the center rail will do. Connect a six inch wire or so to that antenna stickpin on the board, and don't connect the other end to anything.

3) That's what I thought. The board it came from had some physical damage, but I tested the chip in both conventional and TMCC modes (in a known good LCRU1) before sending it to you. Unless it was damaged (see above), it should be fine.

TRW

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×