JohnActon posted:You did not mention programming the LCRU. I am unable to program the LCRU since it is not recognizing the command signal and remains in conventional.
Is it programed and did you move the program / run switch back to run ? The LCRU RF section was a bit flaky, if you hooked the antenna to ground or center rail you may have fried the RF section of the board. I didn't. I did not hook anything to the LCRU antenna other than a hunk of wire with a connector on one end. The "antenna" I referred to above was the wire from the command base - I hooked it to the outer rail, and even tried the inner rail - that shouldn't fry anything.