@stan2004 posted:
1. When you say your present 12V DC LED strips are AC powered, they are directly connected to track-voltage (center-rail roller, outer-rail wheels)?
2. What LEDs did you use for the end lights? In your photo above, if these are the powered end cars, it appears you have green, red, and white lights. Since you say you run DCS presumably these are MTH PS2 and you replaced bulbs with LEDs? That is, PS3 cars are already LED. Just trying to understand what you changed for the end of car lighting and where the power comes from (e.g., a light output on the PS2 harness).
1. Yes.
2. I used standard 3MM white LEDs with 330ohm resistors. Yes, all I did was replaced the bulbs with the LEDs. The R32 (the set on the left and the one I converted, I haven't touched the R40 yet) is a PS2 set.
