Skip to main content

Reply to "Led lights. Did I miss the fine print?"

Should be a resistor under the heat shrink tubing somewhere.  I can see the bulge in your second picture.   Look and see if one led of the led is thicker than the other.   You can use a exacto knife and slit the heat shrink open and take out the resistor.  The led itself should light up around 2 -3 volts.  If not reverse the led wires on your power source and try again.

Last edited by aussteve

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×