irish1 posted:Thanks for the reply . I will try your all of your suggestions. One other question what happens if I clear the cab-2 controller?
It will do just that, clear the Cab-2 no effect to the engine. Now if your hit the “R” in the “0” placement on the Cab-2 that should reset the RCMC and clear the code. But please DO NOT do that until the code is identified, while it could be a fluke it is most likely and actual issue. From your description of everything I believe you are getting “1” blink or in short the motor is stalled. While there are many reasons for this it’s very possible that the RCMC has gone bad but now the question is why? John will have to chime in to help direct you. As I am by no means an expert.
just as a reminder DO NOT reset the RCMC as if I am correct it will try again to move the stalled motor and make things worse.
