I hope I am almost there getting the Legacy-DCS Bridge working. I built the Legacy-DCS bridge as described by Professor Chaos. I down loaded the libraries, successfully compiled and uploaded TMCC_DCS_RFM69 to the bridge. A test oval is set up with both a DCS TIU and a Legacy base station with the serial to PDI adaptor connected to my Legacy-DCS bridge. When the Legacy-DCS bridge is plugged into the PDI bus it blinks several times. A TMCC engine was tested on engine id 58. It functioned correctly on the test track with the Legacy controller. A PS2 engine with engine id 58 was placed on the test track and functioned correctly with a DCS handheld controller. The PS2 engine was shut down and I attempted to turn it on and increase the speed with the Legacy controller. Nothing happened. I then turned on the PS2 engine with the DCS controller. It was idling and I tried to increase the speed with the Legacy controller and Nothing happened. I also tried the front and rear couplers with no success. The Legacy-DCS bridge occasionally blinks but not when I was sending commands. Any suggestions on how to successfully complete the project?
|