Skip to main content

Reply to "Legacy signal problems - extending engine antennas to help the problem"

If you run a ground wire around your layout or in between tracks as suggested above, you need to keep the ground wire approximately two inches away from the outside rails where the other part of the tmcc/legacy signal is connected.  Running a ground wire to close to where you have the U terminal portion of the tmcc/legacy signal connected, will degrade the overall signal.  Also keep this in mind when you run from your command base U terminal to the outside rail.

Bob D

 

Last edited by rad400

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×