Skip to main content

Legacy TMCC Question.

Hi, My layout is all conventional, I have never had or even seen a Legacy  or TMCC layout and have been thinking about getting a Legacy 990 Command Set to use on my layout. I would like to try out some of the newer Legacy motive power engine sets.

 I have three loops that run off a CW-80 and a ZW. All of the loops have the U post / outside rails connected to each other. The two on the ZW is so I can go from the inside loop to the outside loop through a set of switches.  Both of these loops run off the ZW. The CW is got a jumper to connect the outside rails so a set of 252 crossing gates will run off the CW accessory power when a train on either the inside train running on the CW goes through a block or the outside loop train running off the ZW goes through a block.

The question is will this be a problem with the Legacy system operation??

Thanks,

Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×