There are special drills that are made for drilling sheet metal. They have a small pilot in the center to locate the hole and then cut from the outside first. These leave a round hole and not as much of a burr on the backside.
Membership Required
We're sorry. You must be signed in to continue.Sign In
or Register
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
Access to this requires an OGR Forum Supporting Membership
OGR Forum Supporting Membership
Help support this forum with an OGR Forum Supporting Membership. You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM! A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!
OR
Access the ALL the OGR VIDEO FORUMS ANDover 300 back issues of OGR with a DIGITAL SUBSCRIPTION!