winrose46 posted:I am going with mianne benchwork "free Standing lift-gate Sectiion assembly". I have put 1/2 together and I should have the 2nd half done next week. UPS messed Tim up by dropping the box, letting material fall out, and leaving some legs on the warehouse floor. I sent Tim some photos of the UPS damage and I have received a 2nd motor and the missing legs and new sliding leg (bent by UPS) should arrive next week. It raises to 54 inches (and lower if you want) and the operation at York was very nice. I am debating about a 2nd one to accommodate a reversing loop or I might just go with a lift out bridge. Decision will be made once the lift gate is operational.
If the "legs" of my around the walls inverted "U" benchwork I bought from Tim were the same length I would use his product in a heartbeat but unfortunately, he hadn't designed it yet when I purchased the from him. So I built a lift out span of my own using some ideas from other posts like table alignment pins to ensure, what else, alignment of the track when it is replaced. Not as electrically sophisticated as any posted here but it works well. I'll post a few photos later.
Mike
