Skip to main content

Reply to "LionChief plus PRR A5 Backup Light"

The good news is the board is coded for a backup light and the connection for it is through a molex connector with the correct pin stenciled on the board. I had a spare two pin connector I removed the leads and inserted into the existing connector. I ran the leads out of the locomotive and through a two pin harness back to the tender. I used a standard 3V LED and a 470 ohm resistor. I forgot the LED size, but 2mm is what I think it was. It just slipped up into the housing and seated perfectly. I didn’t glue it as I want to change it because all I had was a blue LED. It has been run quite a bit and stayed put! I’ve since gotten a replacement LED, but it’s one of ‘when I got a roundtuit‘ projects!

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×