BC1989 posted:Thanks for the reply. Sorry, I don't know a lot about electricity (less than the average person on this forum, surely): what's a relay? I have the "plug, expand, play" version so I was just going to plug it into the activator Fastrack and go. That doesn't need a relay, right? (Or at least, no relay other than what's already built into the track/accessory?)
Can you put the metal strip back on the track after you take it off?
Thanks!
Yes, that is how to expand the activation zone. be sure to properly align the 5" pieces with the cut rail for isolation on the same rail at the beginning and end of the zone. Then, use regular track with the bars removed in between.
The plug n play system assumes that you are running at fixed voltage for LionChief or Legacy engines. The accessory may not have enough voltage when operating in conventional mode.
Yes, the bars can be replaced to return the track to factory. Use a large wide bladed flat screw driver to work the tabs with the least amount bending. Flat side under to stand it up, edge at the in a vertical position aligned with the tab to bend down.
