Skip to main content

Reply to "Lionel Base 3 questions"

Ok, I agree easer to use the 2 wire interface. Do i need 1 of the LIONEL LEGACY LAYOUT CONTROL SYSTEM DB9 POWER SUPPLY & CABLE o gauge 6-81499. I see this spoken about along with the purchase of SER2 but i am not sure why I should need it?? Do you agree.  Thanks so much for your help in navigating this.

Rich

No, not when using the Base3. This is because specifically a key design point was base3 already supplies power on the PDI ports, so you do NOT need the Y power cable and starter serial PDI chain cable set used for the older 990 Legacy base. Again, Legacy base only had serial, and could not natively supply PDI bus power. So  a special cable and power adapter was sold as a set.

Base3 was designed after LCS and PDI existed- so it natively has powered PDI ports.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×