Skip to main content

Lionel f9 well car loads

Hi everyone,

 

Thought yinz might like to see a couple of loads that I installed on the Lionel f9 well cars that were produced about 15 or so years ago.  The first is a C&O car with 2 large gear loads.  These are actually 4 separate plastic gears made for changing the gear ratios on RC cars.  They are 17/32" wide,  approx. 4" diameter and have a 15/32" bore, and have 57 teeth.  I went to a small local hobby shop and ordered them-they were about $6 each.  I used a 1/2" basswood dowel rod for the shaft and just pressed the gears on the shaft in a bench vise.  The fit was just right and I was still able to rotate the gears on the shaft to get the teeth to line up so it appears to be a wide gear on each shaft.  I painted the gears with red oxide primer and painted the wood shafts with Testors rubber color enamel.  The rubber color is to

simulate the shafts being coated with cosmolene for corrosion protection.  The wood cradle is just 1/4" thick basswood that was made to fit in the well of the car after I took some measurements.  After final fitment and assembly of the cradle,  I stained it golden oak.  I then added the Mesta Machine signs on both sides.  For final assembly into the car,  I put the cradle into the well and attached it with two small screws through the bottom of the car(the holes are already there) and into the wide cross pieces on the base of the cradle.  I then set the gears into the cradle,  and glued the wood caps in place.  I used Elmers wood glue for  all the cradle joints.

The second car is the PRR well car was a quick and dirty load.  I had bought a couple of USA trains G-scale generator loads for a cheap price at a local train show some time ago.  While tinkering around,  the light bulb went off,  and lo and behold the G-scale generator load was a perfect fit for the well car.  The generator already comes mounted on I-beams that have holes in the bottom for screws.  I drilled a couple of holes in the bottom of the well car and had a nice large generator load.  I added a couple pieces of stained basswood for blocking and the car was done.  It's always nice to have something a little different from everyone else.

 

Nick 

IMAG0001

IMAG0003

IMAG0004

IMAG0005

IMAG0007

IMAG0009

IMAG0010

IMAG0012

IMAG0013

IMAG0014

IMAG0015

Attachments

Images (11)
  • IMAG0001
  • IMAG0003
  • IMAG0004
  • IMAG0005
  • IMAG0007
  • IMAG0009
  • IMAG0010
  • IMAG0012
  • IMAG0013
  • IMAG0014
  • IMAG0015
Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×