Skip to main content

Reply to "Lionel Gantry Crane"

The connectors on the newer models are Molex Micro Fit. I made an extension cable using male and female housings and pins crimped to ribbon wire. The attached cable was tucked under the platform and the extension cable run through a slot in the table and glued to one leg using non drying Scenic cement. This is on a portable module where the crane is taken on and off.

 

 

 

Pete

 

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×