Skip to main content

Reply to "Lionel Legacy Engine Blinking Cab Light With DCS"

Is it blinking in a pattern?

If so it may indicate an issue with the engine.  If it's running I doubt it's 1 blink which indicates a motor/drive issue.  2 blinks is the smoke resistor error and 3 blinks is the smoke unit fan error. You can push the R key on the Cab2 or 0 on CAB1 to do a reset and clear the error.  If it comes back something may need serviced  the most common is the fan.

The other possibility is just an engine hard reset to restore features.  Put the engine in PGM.  Push ENG, the #, then AUX1 then 2. Turn off power and move the switch back to run. Page 23 of the manual. Not sure of the DCS key to do the above.

 

Last edited by MartyE

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×