Skip to main content

Reply to "Lionel Odyssey 1 Runaway"

The magnets in the magnet ring aren't that strong, just make sure that the magnet ring is around 1mm from the sensor on the motor.  If that isn't wrong, then you either have a sensor issue or the DCDS motor drive has croaked.  Obviously, make sure the three wires from the sensor board to the DCDS are solid, the runaway symptoms are that the DCDS isn't seeing the tach pulses.

Note that if the 10-pin connector is used for powering lights, you may have to make adjustments there if you convert to the CC-M.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×