From the manual...
If your locomotives are unresponsive to your commands in the TrainMaster Command Control
environment, we recommend that you follow this procedure to reset your locomotive set.
1. Slide the Command reverse unit switch to the PGM position. See pages 7, 32, and 33 for the
locations of the Command reverse unit switches on each unit.
Work with only one locomotive at a time.
2. Plug in and connect your Command Base.
3. Place your locomotive on the track, then power up the track.
4. Press ENG and enter the locomotive’s ID#.
5. Press SET.
6. Press ENG and enter the locomotive’s ID# again.
7. Press AUX1.
8. Enter 78 for this particular locomotive.
9. Turn off track power and wait ten seconds.
10. Slide the Command reverse unit switch back to the RUN position.
Repeat these steps for each locomotive.
At this point, your locomotive set has been reset. Restore power to the track and operate the
locomotive as usual. Be sure to use the ID# entered in Step 4.
