When you get the fix-it flywheel and are installing the magnet, there's a "trick". You'll find the lip that the magnet sets over isn't a close fit, there's some "slop" between the ring and the flywheel. When I glue them on, I use some cardboard spacers to center the ring for the glue job, then remove them when the glue sets.
You apply the glue to the flat surface under the magnet ring, and make SURE the dimples on the ring are on the glue side, the plain side of the magnet ring faces the sensor.
I'm currently using Loctite 380 Black Max for the job, it's never failed me.
I've also used E6000 adhesive, that works fine as well.
I just got e everything I needed. And sure as heck, there is a huge difference in the fix it flywheel circumference where magnet is placed and the original. You also answered my question before asking about glue. Thank you John, you’re a wealth of information. Is there only one set screw with fix it flywheel?
OBX
