Skip to main content

Fixed and Smoking!!! (Looking for input on a Lionel Smoke Unit)

Hey Gang,

I snagged a Lionel Legacy B&O Mikado (6-11280) off ebay for a good price. It was listed with a bad smoke unit, which can easily be fixed. I tore down the smoke unit, measured the resistor, tested the motor, replaced the wick, and checked the wires and pcb for continuity. Everything looked fine, so I put the locomotive back together and put it on the track. The locomotive smoked in idle, but when I put it in gear, the smoke stopped and I got the three blinking lights. 

I have the smoke unit in front of me now. I am going to re-flow solder to all connections in case there is a cold joint, lubricate the motor, and clean up the residue on the resistor.

Will the resistor in the smoke unit still measure in the 8 ohm range if it went bad? I did get smoke last night, so I don't think that is the problem. Could there be a fault in a pcb or wiring upstream? Any thoughts or suggestions would be appreciated.

Stewart

 

Last edited by ChessieFan72
Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×