Skip to main content

Reply to "Lowering MTH (& early Lionel?) PAs"

This is actually going to be A LOT easier than I thought because those holes in the pilot are already tapped in the frame for 2-56 screws. And after chasing out the threads the pilot mounts right up.

I'm going to create a coupler shim that uses these holes and will mount the coupler at the correct height. I'm also to use the same coupler shim, albeit thinner, once I figure out how to lower the frame.

Here's some shots...

imageimageimage

Thanks,
Mario

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×