Skip to main content

Reply to "Marx 1666 Problem"

MM,

thanks for posting the photo's.

You do have the correct pilot, but it's attached incorrectly.

There should be a slot in the front motor mount that the tab/tang on the pilot should slip into.

That screw may be the cause of the problem, by creating a short on the center rail.
If there isn't a slot in the front motor mount, you can try tweaking the pilot frame 15 - 20 degrees below the horizontal plane, in front of the screw to raise it up off the center rail.

Dave

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×