Skip to main content

Reply to "Micro Engineering turnout fix? Darned thing is borken at the points..."

Well, I was going to finish mounting my blue points, leaving this broke turnout until I can try the epoxy, when I ran the last blue point to an OK turnout. That had all the cables connected due to where it was located, and I guess the tension on that while I was trying to get it in place was too much. The piano wire running up from he blue point sliced that points bar in half as well, at the hole, just like the other one! The funny part is that they're adjacent to each other.

DANG IT! no

So now I really need to try this epoxy fix! That'll happen tomorrow night...

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×