Skip to main content

Reply to "Micro Engineering turnout fix? Darned thing is borken at the points..."

We have 40 plus ME #5 turnouts.  The way we got them to work reliably was to replace ALL of the throw tiebars with slightly wider pc board tiebars.  We did not gap them right exactly in the middle.  This leaves a little copper for the throw wire to run and adds to the strength of the hole.  The gap doesn't care where it is so we just gapped them close to one of the running rails.  They ALL work smoothly now.  

For the rail joiner / point problem we moved them into place and then a little CA on the end towards the frog.  They now stay in place.  Russ

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×