Skip to main content

Reply to "MTH Aerotrain DCC problems?"

Perhaps you have clipped the wrong gray wire.  I've done 2 RailKing locomotives and both were a pain.  If I had just gone in and clipped the gray wire I would have gotten the wrong one.  In both cases they were black, not gray.  I very carefully looked at several photos I found online and traced the wire from the connector on the board to find the correct wire.  also, when you clipped the wire, did you put tape or shrink wrap over the end to keep the wire from shorting out on anything?  Did you also make sure you didn't pinch any wires putting the shell back on?

(I might be interested in removed PS-3 boards.  I do have one PS-2 locomotive I wouldn't mind upgrading to PS-3 so I can run it with my other PS-3 locomotives in DCC.)

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×