Skip to main content

Reply to "MTH D/C Can Motor Worm Drive - Lionel Legacy Mabuchi Liondrive Gear Swap"

    You are an Angel John, I was looking for the Program/Run switch wire detail and your post arrived right then. I soldered it in place and then programmed the CAb-2 and the Engine. Nice. I tested the engine, all systems are working with the Cab-2, Android, and the LionChief controller.

   Lionel really did a nice job on the electronics and the wiring of this Legacy version. A Very pleasant surprise indeed! I noticed they didn't use the 9V Battery for the RS Board in this version. Is one needed? 

  The flywheel is still on hold. I haven't found the 2mm version, or a suitable solution... did I mention the lights?

   Best Regards,

   Carl

Last edited by Carl_Wicks_177

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×