Skip to main content

Reply to "MTH engine bell rings constantly when under power"

The failed diode that I mentioned was one of the 4 located on the opposite end of the lower board from the capacitor and fortunately was visibly failed. I had previously tried all the normal diagnostic and reset procedures and the engine would run and respond normally except for that persistent bell. In this case, replacing the diode cured the problem.

 

Eric Hofberg

TCA, LCCA, MTH Tech

Last edited by chug

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×