Skip to main content

Reply to "MTH RailKing Locomotive Issue"

Ted S posted:

It sounds like this might be an early (<1998) PS1.  If you're using a chopped-wave power supply, intermittent or varied chuff rate is a known problem.  You would have to use a sine-wave transformer, or put a 150uF NON-POLAR capacitor across the output of your transformer to smooth the waveform.

It is possible to adjust the chuff rate, but as I remember the procedure involves applying power while holding the loco back, etc.  That's pretty hard on the motor and tires!!

I’m using an MTH z-1000. I guess I’m not sure what a chopped-wave power supply is. 
Good info. I’m just not sure about that level of technical detail but I’ll research it.

 Thanks 😊 

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×