Skip to main content

Reply to "MTH remote control box, in line with Z1000 transformer doesn't work. I wonder why?"

stan2004 posted:

Not sure about using the term splitter and reverse-splitter, but where 3-wires come together I'm simply suggesting something like a twist-on wire nut.  Here's the diagram updated showing the coax power connectors (5.5mm/2.1mm) which are on the input side of the Z-controller and DCS-RC.  The output side of the Z-controller and DCS-RC have red/black banana jacks to which you can insert bare-wires.

mth b

You can buy pig-tail wires with either male or female coax (5.5mm/2.1mm) connectors on them for less than $1 each on eBay.  Or you can use the screw-terminal adapters I showed earlier in the thread.

I am going to have to digest this diagram a bit. I think I understand it but I am not completely clear just yet.

Thanks for the responses.
I really do appreciate it.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×