Skip to main content

Reply to "My Korber #320 Roundhouse Build"

Thanks for the input Norm.
This is what I'm using to power the LEDs. It has a 3 volt side and an adjustable side. The LEDS weren't bight enough with just the fixed 3 volt setting. So I switched to the adjustable side and accidently put in too much voltage and fried the LEDS. It adjusts up to 20 volts. I did have a meter on it, but sinces its mounted on the bottom, I couldn't watch the LEDs and adjusted it too far.

I checked all of the outputs on the board and they are the same. All the + are connected together and all the - are connected together.
I have the LEDs on one frame paralleled together, then into the board to one output. Another frame into another output, etc.

1 x power distribution board self adapt distributor HO N O LED street light hub | eBay

Any suggestions on a regulated 3 volt power supply?  Seems that would be the best of all worlds.
Also, what about the Woodland Scenics lighting system? Anyone using that for LED lighting?

Last edited by Jayhawk500

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×